T-Molding

From BYOAC OLD Wiki
Revision as of 08:52, 21 September 2006 by JoyMonkey (talk | contribs) (Started a basic T-Molding page)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search


The layout of this page is a work in progress. This implementation of this page is being discussed by members of this Wiki. The layout and the way the content is presented is being discussed on [[{{{1}}}|this]] talk page. You are still invited to add content to this page, keep in mind that the layout is not yet final so please read the talk page first.

Please remove this notice {{WorkInProgress}} from the article when is settled on a layout. Inclusion of this notice guarantees that this page will remain tagged for cleanup and listed in the work in progress page.


Illustration from McMaster.com

Since the dawn of time, t-molding has been the edge trim of choice for arcade cabinets. It's low cost and ease of installation made it perfect for companies mass-producing cabinets that wanted a way of making the rough cabinet edges more attractive and resilient to wear and tear.

Installation

Small router with slot-cutting bit

To install t-molding, you must route a 1/16" wide groove into the exposed edges of your cabinet; this is usually done with a router of some kind and a 1/16" slot-cutting bit. Some cabinet builders have mentioned that a Dremel tool can be used for this, though doing so is not recommended.

The t-moldings barbed rib anchors the trim in place and provides a snug fit. The convex-shaped underside flattens against the surface when installed, giving the molding a seamless look against the cabinet parts.

See Also

Retrieved from "http://oldwiki.arcadecontrols.com/index.php?title=T-Molding&oldid=7890"